ShopDreamUp AI ArtDreamUp
Deviation Actions
Suggested Deviants
Suggested Collections
Description
Here's a monogoggle i'm currently working on. I just need the straps, eye-cup protection, then coloring.
You can see the crappy soldering on the inside of the gear. *tear* I fail at doing clean soldering. Took most of my morning getting the solder off on the outside.
Don't pay any mind to the extra leather on the bottom, thats there so the eye-cup can hold its form while drying.
You can see the crappy soldering on the inside of the gear. *tear* I fail at doing clean soldering. Took most of my morning getting the solder off on the outside.
Don't pay any mind to the extra leather on the bottom, thats there so the eye-cup can hold its form while drying.
Image size
1457x955px 162.61 KB
Make
Canon
Model
Canon PowerShot A3000 IS
Shutter Speed
1/20 second
Aperture
F/2.7
Focal Length
6 mm
ISO Speed
800
Date Taken
Jun 18, 2010, 8:48:07 PM
© 2010 - 2024 passbyguy
Comments1
Join the community to add your comment. Already a deviant? Log In
Clean work is imperative (as I am sure you know). I have taken to putting small slivers of solder with good spacing between and if its clean and fluxed well it flows and stays hidden with little clean up. I have found its even stronger than if I have used the feed and flow method as the solder is inside not outside. Nice work all the same.